Eaton Eluxa horn strobe, LED, wall, red, FIRE, clear lens, 15/30/75/110/135/185 cd, 24V, indoor
Product Info
ELUXA LED HN STR RED WALL 24V 15/30/75/110/135/185 FIRE
The ELHSR ELUXA Wall Fire Alarm Horn Strobe 24V by EATON is one of the best fire alarm and CO alarm options in the market, thanks to the three horn pattern it includes: Continuous, T3, T3/T4 in a single device, which not only reduces customers’ inventory but also is an industry first by combining both fire alarm and carbon monoxide (CO) over the same two wires. It also includes six different candela settings for the strobe light. Activation is accomplished through digital communication.
To reduce installation time, Eluxa includes pre-wire/ pre-test via a rigid mounting plate with hinged feature and no tools needed for setting changes. This fire horn is suitable for 24V.
PRODUCT OVERVIEW
Energy efficient
- LED technology provides industry’s lowest current draw for a combined high and low candela device
- Fewer power supplies required, smaller wire gage, reduced wire runs
Compatibility
- UL/ULC listed as compatible with all Fire Alarm Control Panels (FACP) and accessories that have been determined to be compatible with Wheelock RSS strobe-based products and Exceder LED3
- Ability to mix LED and xenon strobes in the same field of view
- Meets stringent synchronizing standards for strobes with Wheelock’s DSM Sync Modules, PS Power Supplies or SAFEPATH products
Low profile design
- One of the smallest, most compact single-gang designs
- Sleek, modern aesthetics with no visible mounting screws
Special lettering
6 Field selectable settings
- Wall: 15, 30, 75, 110, 135, 185 cd
3 Horn patterns
- 3 horn patterns: Continuous, T3, and T3/T4; Fire and CO signaling
Easy-to-install
- Mounting plate included with all models: Convenient capture hinge allows installers to easily hold the device while fastening the single-mount screw in place
- Pre-wire/pre-test capability to check for wiring and ground faults prior to appliance installation
- Finger slide switches—No tools needed for setting changes
- IN/OUT screw terminals using #12 to #18 AWG wires
- Mounting options include ELSBB, any single-gang backbox and to 4” square with adapter kit for wall models and LSPKBB-C backboxes, 4” square, 1 1/2” or 2 1/8”deep and 4” Octagonal, 1 ½” or 2 1/8”deep for ceiling models
Compliance & approvals
- NFPA 72 2016 (meets maximum light pulse duration of 20 ms)
- UL 1971, UL 1638, UL 464; ULC-S525, ULC-S526
- California State Fire Marshal (CSFM)
- ADA/NFPA/ANSI/OSHA
Export To PDF