ETHERNET PORT FROM DATA BUS EXPANDER/INT
Product Info
ETHERNET PORT FROM DATA BUS EXPANDER/INTERFACE
The ELK-M1XEP is an Ethernet Appliance with a RS-232 Serial Port Interface. It may be used to connect a control in the M1 Family to an Ethernet network. It features email event notification and FIPS compliant encryption algorithms for security sensitive environments. It is powered by an ELK-P1216 12 Volts DC, 1.5 Amp plug-in power supply/adapter. A software setup utility is built into ElkRP for configuring the connection setup, network password, etc. The M1 Ethernet Interface is factory defaulted to obtain a dynamic IP address from a DHCP server (i.e. router, cable modem, etc.). It may optionally be setup with a static IP address.
Features:
Secure connection with password protection and SSL/TLS encryption
Flash Memory for Firmware Updating
Event notification via E-Mail (SMTP)
Supports automatic Dynamic DNS Updates with providers using the DynDNS protocol.
Supports Network Time Protocol for synchronizing the M1/EZ8’s clock with an Internet time server.
Internet Monitoring and Reporting Capability
Network stack supporting the following protocols:
-TCP,UDP,DHCP,SSL/TLS, NTP, SMTP
Federal Information Processing Standards (FIPS) 128 bit encryption
Integrated 802.3 compliant 10/100 Mbit network interface
RS232, DB9M 9-pin serial port connection
Connects to the M1 RS-232 Serial port (Port 0). The baud rate for this port must be set to 115,200 (factory default)
RJ45 8-pin Network Jack
2.1mm barrel type power connector (center positive)
LED Indicators for Power, Link, and Data
Specifications:
Operating Voltage: 12 Volts D.C. from Elk-P1216 Plug-in Power Supply
Current Draw: approx. 300 mA
Housing Dimensions: 4.25” x 6.375” x 2.125”
Circuit Board Dimensions: 2.25” x 3.95”
ELK-W040A Serial Ribbon Cable included
What’s Included:
M1 Ethernet Interface
Plastic Housing
4 #6 Plastic Anchors
4 #6 Pan Head Sheet Metal Screws
ELK-P1216 1.6A, 12Vdc Power Supply
ELK-W040A DB9 Pin Serial Cable Assembly
Instructions