Search Results

Product Features
3 horn patterns

• Continuous, T3, and T3/T4
• Fire and CO signaling in 1 device
  Mounting settings
• Ceiling
  Special lettering
• Smallest footprint with sleek, modern aesthetics
  Easy-to-install
• Mounting plate included with all models: Convenient capture hinge allows installers to easily hold the device while fastening the singlemount screw in place
• Finger slide switches—No tools needed for setting changes? Built-in level adjustment feature and snap-on grille cover? IN/OUT screw terminals using #12 to #18 AWG wires?* Mounting options include ELSPKBB backboxes, single-gang backboxes and 4” square backboxes for wall models and LSPKBB-C backboxes and 4” square, 2 1/8” deep backboxes for ceiling models
  Compliance
• UL 1971, UL 1638, UL 464, ULC S525, ULC S526
• California State Fire Marshal (CSFM)?* ADA/NFPA/ANSI/OSHA

The new memory module will be used on the 1830 series entry systems. It will function identically to the old memory chip, which is obsolete, and plugs into the current memory chip socket. The arrow on the module is to be pointed UP, much like the dot and notch on the old chip.

The new module also has an LED labeled ACT, which flashes when the 1830 systems processor is accessing the memory module (like a hard drive LED on a computer).

The new module is interchangeable with the old memory chips and can be used in older phone systems. Part numbers for the old chip and new memory module are shown below.

Used with Doorking 1834 system

The DoorKing 9410-010 single channel loop detector is designed for exclusive use with DoorKing vehicular gate operators and control an individual loop (including 2 series wired reversing loops configuration). The 9410-010 plugs into loop detector ports on the grate operator control board. The “self-tuning” unit will constantly monitor the loop’s frequency status and “self-tune” for any minor deviations with the frequencies to keep the loop operating normally and decrease false calls.

Use with Switch2 or Net2. Keypad and proximity reader all in one. Range up to 100mm with PROXIMITY cards. Easy mounting. Low profile – less than 16mm deep.
About – KP readers are a keypad and a proximity reader all in one. This allows card plus PIN (or code) access control with a single reader. KP readers are for use with Switch2 and Net2 systems. The KP series keypads are supplied with black bezels only. Replacement bezels are available in black and white/gray, and are free of charge to Paxton registered installers from the Extranet.
Installation – The reader is wired as shown on the control unit label. Be sure to avoid mounting on metal surfaces or near other proximity readers as this will affect the read range. The cable exits centrally from the back of the reader making drilling and mounting very accurate.
Operation – A token is read by holding it within close proximity of the reader. Once a token has been read if the reader has been configured for code/PIN this must then be en

The NXT-MSC-KIT4 from Keri Systems is a NXT Four Door Distributor Kit Contains (1) NXT-4DMSC Controller, (4) NXT-3R Mullion Readers, (1) DNET-APP doors.net, (1) KPS-3 Power Supply, (4) NXT-C Clamshell Cards, (4) NXT-K Key Tags, (4) NXT-I ISO Imageable Card.