Search in Category
Filter Your Search
Brand
Shop by Category
Shop Intrusion Accessories
DUAL BATTERY HOOKUP WIRES F/ELK CONTROLS
Increase the back-up battery capacity of M1 control by installing dual back-up batteries. Replaces factory battery wires.
Qolsys IQP4BASE-BLK IQ Panel 4 Base
Bluetooth Music Streaming through IQP4, QuadSound Speakers (Black)
M & G ELECTRONIC SALES CORP BUS TERMINAL STRIP 1IN 6 OUT
One example of the usefulness of this bus terminal expander is to de-clutter your power terminals. Run the negative to one side of the terminal expander and the positive to the other side and then all your power wires, for example your keypads, into the other terminals on the expander. Add another DT-600 for the data wires of your keypads and you clean up the terminals on the main board.
STAND-OFFS FOR CIRCUIT BOARDS(10PK)
For attaching M1 expansion boards and other manufacturer’s boards to the ELK-SWP3 and ELK-SWP4 Plates.
PWRSUPPLY & CHARGER BD KIT W/5AH BATTERY
The ELK-P1215K Power Supply/Battery Charger Kit is a plug-in 14VDC Power Supply (ELK-P1417) combined with an intelligent Charger Board and a 12V 5Ah Battery(ELK-1250). It can supply up to 1.5 Amps of current at 12VDC (nominal). The charger board features a Low Battery Supervision output, Low Battery Cutoff, as well as a Manual On/Off switch. The Power Supply features built-in overload reset and screw terminals for connections.
Bosch 1K 1/2W EOL RES 8/PKG
1K 1/2W EOL RES 8/PKG. The P105F EOL resistor is a 1 kO, 0.5 W resistor with 18 AWG (1.2 mm), violet wire leads (each approximately 15 cm [6 in.] long). It is used as an end-of-line resistor for loop supervision and is supplied in packages of eight.
SERIAL TO LUTRON RADIORA 2 MAIN REPEATER
The ELK-M1XSLU is a dedicated Elk-M1 serial expander for connecting an M1 Control to a Lutron RadioRA2 Main Repeater. RadioRA2 is a wireless multi-room control system for Lights, Shades, and HVAC Thermostats. Interfacing a RadioRA2 system to an M1 allows control in response to security system actions or conditions. With the automation and remote capabilities built into M1 it is possible to control RadioRA2 devices from across the room or across the world. Benefits include energy savings, convenience, and comfort.
The M1XSLU should be mounted as close as possible to the RadioRA2 Main Repeater. An 18” 9-pin flat ribbon serial interconnect cable is provided.
UNIVERSAL MOUNTING RAIL(2PK) NOT REQ'D
A package of 2 universal rails to mount adapter plates and modules; such as,Telephone, CATV, or Network modules. Accommodates modules from Leviton, OnQ, OpenHouse, and others. Can be mounted to plywood or other manufacturer’s structured wiring boxes.
