Shop ALTRONIX CORPORATION | Brands We Sell

Altronix SMP3 power supply/charger converts a low voltage AC input into a 6VDC, 12VDC or 24VDC output. This unit has a wide range of applications for access control, security and CCTV system accessories that require additional power.

Input Voltage
6VDC or 12VDC operation.
Current draw: 120mA.
Contact Rating
5A/220VAC or 28VDC DPDT contacts.
Temperature
Operating: -25ºC to 55ºC ( -13ºF to 131ºF).
Storage: -25ºC to 70ºC ( -13ºF to 158ºF).
Relative Humidity: 85% +/- 5%.

SMP5 power supply/charger converts a low voltage AC input into a 6VDC, 12VDC or 24VDC output. This unit has a wide range of applications for access control, security and CCTV system accessories that require additional power.

Altronix AL600ULACM converts a 115VAC 60Hz input into eight (8) independently controlled 12VDC or 24VDC Fail-Safe and/or Fail-Secure outputs with a total of 6A continuous supply current. These power outputs can be converted to dry form “C” contacts. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. This unit will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. The outputs will operate in both Fail-Safe and/or Fail-Secure modes. This unit is designed to be powered by one common power source (factory installed) which will provide power for both the board operation and locking devices, or two (2) totally independent power sources, one (1) providing power for board operation and the other for lock / accessory power. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigg

6062 programmable timer is suitable for many functions that require a timed operation e.g. Access Control Applications, Siren/Bell Cut Off Module, Dialer Delay, Guard Tour Supervisory Timer, etc. Some optional functions include: One Shot, Delayed Release, Delayed Operate, Delayed Pulse and Pulser/Flasher.

Input
Voltage: 12VDC or 24VDC operation.
Current draw: 75mA.
Contact Rating
5A/220VAC or 28VDC DPDT contacts.
Indicators (LED)
Trigger: Relay is triggered
Remote LED status output
Temperature
Operating temperature: -25ºC to 55ºC (-13ºF to 131ºF).
Storage temperature: -25ºC to 70ºC (-13ºF to 158ºF).
Relative Humidity: 85% +/-5%.

Altronix SMP3ET power supply/charger converts a low voltage AC input into a 6VDC or 12VDC output. This unit has a wide range of applications for access control, security and CCTV system accessories that require additional power.

The ALSD2 are high output, very low current draw, dual channel siren drivers. They are designed to work with alarm panels with limited current capability.

Altronix AL624 linear power supply/charger converts a low voltage AC input into 6VDC, 12VDC or 24VDC output. This general purpose power supply has a wide range of applications for access control, security, and CCTV system accessories that require additional power.

Altronix AL802ULADA is an extremely cost effective voltage regulated remote NAC Power Extender. It may be connected to any 24 volt Fire Alarm Control Panel (FACP). Primary applications include Notification Appliance Circuit (NAC) expansion (supports ADA requirements) and providing auxiliary power to support system accessories.