Browse Categories

Search in Category

Detection Devices

Shop by Category

Loading...

Shop Detection Devices

DUCT DETECTOR TEST SWITCH

DUCT DETECTOR TEST SWITCH

Item #: POT-PAD100-DRTS

Supplier Part #: PAD100-DRTS

The PAD100-DRTS module does not require an SLC loop address. The PAD100-DRTS provides a supervised remote test switch for the PAD100-DUCTR duct detector. Active and Pilot LEDs provide status of the PAD100-DUCTR detector. Keyed switch allows remote testing of the PAD100-DUCTR duct detector.

IN STOCK
ADDRESSABLE SLC PULL STATION

ADDRESSABLE SLC PULL STATION

Item #: NAP-FWCFSLCPULL

Supplier Part #: FWCFSLCPULL

The FWC-FSLC-PULL series are the Napco series of addressable manual pull stations that provide a fast and practical means of manually initiating a fire alarm signal. Both single-action and dual-action manual pull stations are available. Resetting of the pull station requires either a Cat 30 key or a 1/8” hex key (depending upon the model used).

IN STOCK
ADDRESSABLE ANALOG SLC HEAT DETECTOR 135

ADDRESSABLE ANALOG SLC HEAT DETECTOR 135


Supplier Part #: FWC-FSLC-HEAT

Addressable SLC Heat Detector 135°F

IN STOCK
ADDRESSABLE SLCSINGLE MINI

ADDRESSABLE SLCSINGLE MINI

Item #: NAP-FWCFSLCEZM1

Supplier Part #: FWCFSLCEZM1

The Napco FWC-FSLC-EZM1 Fast Response Contact Module and FWC-FSLC-EZM2 Dual Input Monitor Module are designed to be used with pull stations, water flow switches, and other applications requiring the monitoring of dry contact devices. The interrupt driven communications protocol combines maximum communication reliability and fast response to emergency conditions. The FWC-FSLC-EZM1 and FWCFSLC-EZM2 contact monitoring modules do not require a separate 24VDC power source.

IN STOCK
PHOTOELECT. 4WIRE DETECTOR & HEAT W/BASE

System Sensor i³™ Series Smoke Detectors with Sounder, Relay and Isolator Options

Item #: SYS-4WTAR-B

Supplier Part #: 4WTAR-B

i³™ Series offers conventional smoke detectors with sounder, relay and isolator features included.

IN STOCK
SIGNALINK BRIDGE WIRELESS SYST

SIGNALINK BRIDGE WIRELESS SYST

Item #: POT-WSS-POTTER

Supplier Part #: WSS

The SignaLink Bridge Wireless Supervisory System can monitor any dry-contact switch such as tamper or flow switches and transmit their status wirelessly to any fire alarm panel. SignaLink Bridge uses a wireless transmitter, installed with the switch being monitored, and a wireless receiver, installed with the fire alarm panel, to fully monitor the switch’s state.

IN STOCK
ADDRESSABLE SLC 2 ZONE CONVENT

ADDRESSABLE SLC 2 ZONE CONVENT

Item #: NAP-FWCFSLCEZM2

Supplier Part #: FWCFSLCEZM2

The Napco FWC-FSLC-EZM2 Dual Input Monitor Module is designed to be used with pull stations, water flow switches, and other applications requiring the monitoring of dry contact devices. The interrupt driven communications protocol combines maximum communication reliability and fast response to emergency conditions. The FWCFSLC-EZM2 contact monitoring modules does not require a separate 24VDC power source.

IN STOCK
PHOTOELEC. 4WIRE SENSOR W/HEAT & BASE

System Sensor i³™ Series Smoke Detectors with Sounder, Relay and Isolator Options

Item #: SYS-4WITAR-B

Supplier Part #: 4WITAR-B

i³™ Series offers conventional smoke detectors with sounder, relay and isolator features included.

IN STOCK
NAPCO 2 WIRE PHOTOELECTRIC

NAPCO 2 WIRE PHOTOELECTRIC

Item #: NAP-FW2S

Supplier Part #: FW2S

The Napco Firewolf FW-2 advanced photoelectric smoke detectors utilize two bi colored LEDs for indication of status. In a normal standby condition, the LEDs will flash green every 3 seconds. When the detector senses that its sensitivity has drifted outside the UL Listed sensitivity window, the LEDs will flash red every 3 seconds. When the detector senses smoke and goes into alarm, the status LEDs will latch on red.

IN STOCK
WATERFLOW SWITH 6" VANE TYPE

WATERFLOW SWITH 6" VANE TYPE

Item #: POT-VSR6

Supplier Part #: VSR-6

The Potter VSR is a vane type waterflow switch with non-corrosive insert for use on wet sprinkler systems. It is UL Listed and FM Approved for use on steel pipe. Models available for pipe sizes 2” through 10”. The Potter VSR series is the industry standard for flow switches for fire sprinkler systems and is compatible with the widest range of pipe schedules (5 through 40) in the industry as well as all necessary listings and approvals for installation worldwide.

IN STOCK
  • « PREV
  • 1
  • 2
  • 3
  • 4
  • 5
  • NEXT »