Search Results

The ENFORCER SD-H412 Electric Transfer Hinge provides a vandal-resistant method for protecting and concealing wires between a hollow door and door frame. It is suitable for low-voltage, low-current applications such as electric door strikes, locksets, and deadbolts or other monitoring or exit devices and is easily installed, replacing the center hinge.

Shunt ON/OFF 2 terminals, SPST
Maintained ON-OFF, key removable from both ON and OFF positions
Commonly used as ON/OFF switch to arm/disarm alarm or shunt zone
Rated 2 Amps @ 12VDC
N.O. Turn to close
Key Number – 1301

Stainless-steel slimline plate with 3/4” (19mm) D-hole

Seco-Larm MVS-AH51-01NQ HDMI Switcher, 5 HDMI Inputs, supports up to 4K/2K resolution and 3D video, individual status LEDs for each HDMI input, switch will automatically select the active input for added convenience, includes remote control for switching between inputs.

New end caps come off and go on in seconds
Designed to allow egress from inside an area normally locked by an electric lock or electromagnetic lock, and/or to disarm (shunt) or trigger an alarm when the door is opened
Rugged, heavy-duty construction
Pushing the bar at any point sends a signal to release the lock and/or sound an alarm
For 36 inch doors (actual length is 34.5 inches)
Includes 2 built-in non-latching (momentary), dual-contact switches (NO/COM/NC), rated 25A@24VAC
Attractive brushed-aluminum bar with black base and trim
Includes SECO-LARM SD-969-A18Q Armored Door Cord, and mounting hardware (for mounting in wood or metal doors)
Designed for easy cutting in field to match width of non-standard-sized doors

The ENFORCER Outdoor Double-Gang Wave-to-Open Sensor with Manual Override is a full-featured exit plate using IR technology to allow egress from a protected area or activate a device with a simple wave of a hand. Since no touch is required, it is suitable for use in hospitals, clinics, labs, cleanrooms, schools, factories, or offices. The manual override button allows operation during a power failure.

SECO-LARM Electric Deadbolts add concealed deadbolt security to most wood or hollow metal doors, with the convenience of electrical operation. They are designed for hollow metal door frames and not recommended for wooden door frames, though the door can be wood or metal.

The Seco-Larm E-931-S50RRLQ is an ENFORCER large reflective photoelectric beam sensor with large reflector. The sensor features a range of up to 50 ft. (15m). The reflective beam provides reliable perimeter security, minimizing false alarms from falling leaves, birds, etc.

Designed to carry wiring to conduct power to electric locks or access systems
Once mounted, simply remove cover to access. Door cord stays in place. No need to remove from the door. Prevents stripping of the screws and mounting points
Surface-mounted
Terminal blocks with pre-wired cables (8 connections) for quick, easy, and secure installation
Maximum current – 3A@30VAC/VDC
15” (39cm) Stainless steel armored cord
Inside door-cord diameter: 5/16” (8mm)
Outside door-cord diameter: 7/16” (11mm)
End cap dimensions: 2-3/16?x7/8?x1-9/16?
Security screws (included) prevent tampering

The ENFORCER Surface-Mount Wave-to-Open Sensor with Manual Override Button is a full-featured exit plate which uses IR technology to allow egress from a protected area or activate a device with the simple wave of a hand. Since no touch is required, this sensor is suitable for use in hospitals, clinics, labs, cleanrooms (to reduce the risk of contamination), schools, factories, or offices. A manual override allows for operation if the sensor is disabled.