Search Results

The ENFORCER Request-to-Exit Plates with Pneumatic Timer are ideal when providing power to a timer is inconvenient, hazardous, or not conforming with local ordinances and codes. Adjusting the time is easy via a timing screw and can be performed on the spot without tools.

These tough stainless-steel plates securely and attractively finish your access-control projects. The included N.C. (turn-to-open) pre-wired keylock switch connects to electromagnetic door locks, gate locks, or other access devices to temporarily or permanently allow entry into or exit from a protected premises by cutting power.

The ENFORCER Weather-Resistant Mushroom-Cap RTE Plates are ideal for many outdoor access situations, with a 1-1/2? (38mm) diameter mushroom-cap (green or red), single-gang faceplate and NO/NC contact rated 3A@24VDC

Easy 2-wire installation, regardless of voltage
If the strobe light is being powered by a backup battery, as the battery is drained, the strobe light will continue to function
Perfect for “informative” burglar alarm use
Incorrect polarity cannot damage circuit or draw current
Low current consumption with long operating lifespan of over 300 continuous hours (2,000,000 flashes)
Lens is made of high-impact and heat-resistant acryrex and case is made of high-impact resistant black ABS plastic
Comes with protective inner cover, which protects the high-voltage Xenon tube when the colored lens has been removed.

The SK-910R4Q is a wireless receiver that meets the growing demand for multi-channel receivers with multiple and independently controlled output modes. RF receivers can be used to control a variety of home automation devices such as garage door openers, lights, motorized gates, lifts, or other devices remotely. These receivers are compatible with both fixed code and code hopping transmitters. Code hopping transmitters, such as SECO-LARM CODEBUMP™ transmitters, change codes every time transmitter sends a signal for extra security.

Fits most metal or wood doors with minimum cutting of the door frame beyond the hole for the strike.

Seco-Larm E936S35RRGQ Reflective Photobeam Sensor, range: up to 35ft (10m), 12-30VDC/VAC 60Hz 100mA, monitored output: N.C./10k resistor, dual-color LED alignment, pre-wired 6ft (1.8m) cord, weatherproof for indoor and outdoor use (IP66), light-on operation).

The ENFORCER Wireless Intercom is a simple and secure way to communicate between multiple intercoms (up to 16 units) within an area of up to 1,000ft (300m). The wireless intercoms operate on 4 channels and can either broadcast to all intercoms or to select intercoms on the same channel.

The SK-910RBQ series of wireless receivers meet the growing demand for receivers with multiple, independently-controlled output functions. These RF receivers are compatible with both code hopping and fixed code transmitters. The receivers can be used to remotely control a variety of home automation devices such as garage door openers, lights, motorized gates, lifts, or other devices.