Shop POTTER ELECTRIC SIGNAL CO. | Brands We Sell

The AMS-38 Mechanical Surface Mount Contact is a UL listed and AC rated contact designed to endure higher voltages than other standard reed contact switches. The AMS-38 can be used to protect openings or to activate other applications such as lighting, sounders, or any other secondary function.

The LFHS is a high quality, low profile, low frequency audible and visible appliance that offers a dependable audible and visual alarm. The LFHS is ideal for any occupancy that requires low frequency notification appliances. The LFHS horn offers a 520 Hz square wave, temporal 3 tone. A jumper selection is available for normal or loud decibel tone. The LFHS is available in a fixed 15, 110 and 177 candela strobe. A temporal 4 pattern is available when used with compatible panels or GTSM sync module. The LFHS is available in a fixed 15, 110, or 177 candela strobe.

The RLY-5 is a relay expander for the PFC-6000 and Potter Plus series panels. The RLY-5 communicates with the control panel via the Potter P-Link communication bus providing 5 user configurable relay outputs. The relay board is mounted in either the control panel cabinet, the PSN-1000/E, the AE-8 or the AE-14 expander cabinet. Each card is mounted to the exclusive Stacker Bracket for secure and accessible mounting.

The AE-2 expansion enclosure accommodates up to 2 standard size PAD100-SLCe, RLY-5, or other stacker bracket sized cards. The enclosure size is (WxHxD) 9 3/4” x 8” x 2 1/2”.

The AMS-37 Series Industrial Magnetic Contact is a UL Listed magnetic contact built for rugged environments and practically any opening. It is designed to provide clean and quick installations. The AMS-37 Series can be used to protect openings such as: man doors, overhead doors, roof hatches, or hinged skylights.

The SB Series is a 6” polarized base with annunciator output featuring a current limiting resistor, and a blocking diode to enhance annunciator function. The SB Series Smoke Detector base is designed specifically for use with the Potter Smoke Detector Models IS-24, PS-24 and PS-24H.These detectors will not sense fires which start where smoke does not reach the detector.
Compatibility – All Potter release panels; Not for use with PFC3000, 5000, 9000 Series panels; Check other panel manufacturer’s compatibility listings.

These vibrating type bells are designed for use as fire, burglar or general signaling devices. They have low power consumption and high decibel ratings. The unit mounts on a standard 4” (101mm) square electrical box for indoor use or on a model BBK-1 weatherproof backbox or BBX-1 deep weatherproof backbox for outdoor applications.

The PAD200-DUCT is designed and built to meet all local requirements, as well as the NFPA regulations regarding duct smoke detectors. Air sampling is accomplished by two tubes which protrude into the duct. An exhaust tube of one standard length (7”) is supplied in the installation kit with the smoke duct unit. Once the duct width has been determined the air intake sampling tubes must be ordered. Sampling tubes are supplied in three standard lengths: 2.5 ft., 5 ft., and 10 ft. and cut to size to fit the duct. Mounting the duct smoke unit is accomplished by the use of a template and 2 sheet metal screws, which are provided. Mounting can be achieved without the removal of the clear cover which is secured by 4 capture screws.
Enhanced sensor technology allows the PAD200 Detector Series to comply with the new UL 268 7th edition standards while bringing customers an even higher standard in smoke detection.