Search in Category
Shop by Category
Shop Wireless
QS1332-840 - Qolsys IQ Wireless S-Line Panic Button Pendant (w/Neck Lanyard)
Emergency panic signal, water resistant, S-Line encryption, and backwards compatibility for legacy 319.5 systems.
ALULA CRYPTIX COMPATIBLE SMK W/HEAT
The Alula RE614 is a Connect+ encrypted, wireless smoke and heat alarm sensor designed for the Alula Connect+ security control panel. The RE614 smoke alarm detector is a fire-protection device that alarms when it detects smoke or temperatures above 135°F (57°C).
NORTEK SEC & CONTROL/LINEAR SMOKE HEAT FREEZE E SERIES
The 2GIG Smoke Heat Freeze Detectors are designed to recognize smoke from common synthetic materials and decrease nuisance alarms from everyday cooking. Using advanced detection algorithms and a sophisticated photo-electric optical sensor, these two detectors meet the new UL standards for the year 2020*.
The new 2GIG Smoke Heat Freeze Detector has been designed to detect fire issues earlier, providing a more accurate and timely notice in the event of smoke or fire.
DSC POWERG 915MHZ WIRELESS SLIMLINE 4-BUTTON
4 programmable function keys
Visual and audible indicator to acknowledge requested action
Full 3-seconds delay on panic function to reduce false alarms
Visible signal quality indication shown on the device
Prolonged battery life (5 years with typical use)
Dimensions: 60 × 34.5 × 12.5mm (2.3 × 1.3 × 0.5in)
Certified with ULC Wireless Commercial Burglary Listing under ULC-S304-16 Standard – an industry first in Canada!*
QS1331-840 - Qolsys IQ Wireless S-Line Remote Alarm Keyfob
Wireless keychain remote with arm/disarm and S-Line 319.5 MHz Encryption
ALULA STANDARD DOOR/WINDOW
The Alula RE601 is a CryptiX-encrypted, standard-sized, wireless door or window sensor. The RE601 is a full-featured security transmitter with industry-leading wireless range and battery life. It is typically used to sense opening and closing of doors and windows, but can secure just about anything using its two external contact zones. The RE601 will alarm when the magnet is pulled away from the sensor or when an external contact is opened.
2GIG SUPER SWITCH WIRELESS TAKEOVER MODULE
The 2GIG-TAKE-345 super switch wireless takeover module is a device that boosts wireless capabilities and coverts 8 hardwired zones into 8 wireless zones. The 2GIG-TAKE-345 works with existing 12-volt control panels. The module is to be mounted next to the existing control panel where the hardwired zones are connected. All of the zones on the super switch act as supervised wireless zones has a 350 feet wireless signal range, and is very easy to install.??Please note, that if the control panel has been removed then a 12 volt power supply with battery backup is required (not supplied).
CINCH Systems, Inc CMDWS (MINI DWS) EXTENDED
Description:
The Extended Door/Window Sensor is a supervised, wireless sensor that detects the opening and closing of doors or windows. The sensor and magnet are mounted using screws (included) or double-sided adhesive tape (included).When activated, the sensor transmits an open (trip) or close (restore) signal to the panel. These are the signals the unit provides: supervisory, tamper, and low battery (as needed). The sensor is powered by (2) replaceable 3- VDC, lithium coin-cell batteries.
50X50 WIRELESS PIR W/40LB PET PROTECTION
The GEM-PIR is an advanced PIR sensor designed for use with Napco’s GEM-Series wireless receivers. The unit is powered by two 3-volt lithium batteries (supplied) for long service life. When battery voltage drops below normal, a low-battery report will be sent to the receiver (replace with Duracell DL123A or Varta/ Power-One CR123A only). Coding switches are not used in the GEM-PIR. Each transmitter has a unique factory-programmed RF ID code (printed on the unit) that distinguishes itself to the receiver. (Note: See control-panel instructions for entering this six digit hexadecimal code and checksum digit into the panel; be sure to enter all numbers and/or letters, including leading zeros, if any).