Shop Wireless

Allows panel to sit at two different viewing angles, with sleek form factor, including bumper pads to protect furniture and prevent sliding.
Works with the 2GIG EDGE panel and the 2GIG EDGE Remote Keypad.

Door Sensor with 319.5 MHz S-Line encryption for recessed door applications

Sensor with 319.5 MHz S-Line encryption detects high (above 100) and low (below 40) temps

Large enclosure, backup battery charging, 500mA of 12volt aux power, onboard siren relay, built-in status LED’s for each zone & support for up to 10 two-wire smoke detectors.

The Gemini Wireless RF Receiver is the hardwired
interface to NAPCO’s Wireless-Ready™ Gemini C-Series
control panels

Description:
The RF-SHK-319 is a wireless window sensor designed for dual protection; open and close and to detect vibrations made by an intruder attempting to break a window. The shock sensor contains a piezo detection device that detects vibrations when mounted on a window frame. The detection circuit can be adjusted for sensitivity during installation to ensure maximum coverage. The device also has a built-in reed switch to monitor the open and close of the door or window.
When activated, the sensor transmits a signal to the control panel. These are the signals the unit provides: supervisory, tamper and low battery (as needed). The sensor is powered by (2) replaceable 3- VDC, lithium coin-cell batteries.

The ELK-M1XRF319 is a Wireless (RF) Receiver and Input Expander for use with the ELK-M1 and ELK-M1EZ8 Controls. The receiver connects to the four (4) wire data (keypad) bus of the control and integrates in much the same way as a M1XIN hardware zone expander except that a single M1XRF can handle up to 144 wireless zones (e.g. transmitter sensors or points).
The M1XRFEG receiver is a dual (2) antenna, phase diversity design capable of long range wireless coverage. It is compatible with ELK’s 319 Series Wireless Sensors, as well as other 319.5MHz sensors (Interlogix format).

The Alula RE663 is an Connect+ encrypted wireless LED alarm keypad with that is designed for the Connect+ control panel. The RE663 keypad is easy to use with 6 one-touch buttons that the user to disarm, arm in stay mode, alarm in away mode, night mode, silent arm and instant arm by pressing just one button. The RE663 LED keypad can be mounted to a wall or placed on a table. The keypad has backlit keys and an LED light bar to provide visual arming status. Amber colors on the corner of the keypad indicate a trouble condition. The light bar blinks periodically and will double blink periodically if zones are open. It can be battery operated or powered by existing AC. To trigger a panic alarm, hold the asterisk and pound button simultaneously.

Dark enclosure, (dark brown) plastic only, package of 5 bases/cover and magnet enclosure bases/covers

Ensure your 2GIG EDGE Security Panel is always online with the 2GIG EDGE Panel Replacement Backup Battery. This replacement backup power supply is designed specifically for the 2GIG-EDG-NA-AA and 2GIG-EDG-NA-VA Security Panels and keeps them active when their main power supply is offline or disconnected. The Backup Battery charges through its connected EDGE Security Panels while they are being regularly powered. The 2GIG EDGE Panel Replacement Backup Battery can keep the 2GIG Edge System operational for approximately 24 hours. The battery has an expected lifespan of at least five (5) years.