Shop Wireless

Description:
The RF-SHK-319 is a wireless window sensor designed for dual protection; open and close and to detect vibrations made by an intruder attempting to break a window. The shock sensor contains a piezo detection device that detects vibrations when mounted on a window frame. The detection circuit can be adjusted for sensitivity during installation to ensure maximum coverage. The device also has a built-in reed switch to monitor the open and close of the door or window.
When activated, the sensor transmits a signal to the control panel. These are the signals the unit provides: supervisory, tamper and low battery (as needed). The sensor is powered by (2) replaceable 3- VDC, lithium coin-cell batteries.

The 2GIG-DW20R-345 is a recessed wireless door and window contact that disappears in the shadow of the door or window frame, leaving intruders unaware of the protected entrance. This small frame sensor is so sensitive, that it can detect even the softest opening and closing of the entrances, making it a great option for enforcing curfew as well. The 2GIG-DW20R-345 communicates wirelessly with the control panel via the 345 MHz frequency. Powered by a replaceable three-volt lithium battery, the DW20R-345 sensor will last around five years with normal use.

Large enclosure, backup battery charging, 500mA of 12volt aux power, onboard siren relay, built-in status LED’s for each zone & support for up to 10 two-wire smoke detectors.

Wherever the possibility of unwanted water exists in a home or business—the compact Wireless Water Sensor is the ideal “peace of mind” sensor to add to your security and life safety system. If the possibility of unwanted water exists from: toilet overflow, hose leak, sump pump failure, or pipe leak—the Water Sensor is on guard to alert of water accumulation and damage. Sensor detects water as little as 1/32”; when water rises to the contacts. Sensor checks for water every 5 minutes and requires two positive checks for a valid alarm—reducing false alarms.

The RE30 is a Universal Translator Battery Pack for Alula products. 

Wireless Glassbreak Transmitter

The kit includes a Power Supply Board with backup battery charging circuit, a Plug-in Transformer, and a ABS plastic enclosure that includes a dedicated space for your backup battery (battery not included).

The enclosure houses up to (3) Super Switch Takeover Modules, which increases your capacity to convert up to 24 wired sensors to wireless zones.
The 2GIG Hardwire Enclosure Kit (2GIG-TAKE-ENCL) does not include any Super Switch Takeover Module

Ensure your 2GIG EDGE Security Panel is always online with the 2GIG EDGE Panel Replacement Backup Battery. This replacement backup power supply is designed specifically for the 2GIG-EDG-NA-AA and 2GIG-EDG-NA-VA Security Panels and keeps them active when their main power supply is offline or disconnected. The Backup Battery charges through its connected EDGE Security Panels while they are being regularly powered. The 2GIG EDGE Panel Replacement Backup Battery can keep the 2GIG Edge System operational for approximately 24 hours. The battery has an expected lifespan of at least five (5) years.

The Alula RE214 Honeywell Compatible Wireless Smoke Detector is a highly reliable smoke detector with a photoelectric detection element and built-in temporal 3 sounder. Long-range transmitter and a detection element that is UL217 certified.

The ELK-M1XRF2H is a Wireless (RF) Receiver and Input Expander for use with the ELK-M1 and ELK-M1EZ8 Controls. This receiver is compatible with Honeywell (Ademco) 5800 series wireless transmitters. The M1XRF2H connects to the four (4) wire data (keypad) bus of the control and integrates in much the same way as a M1XIN hardware zone expander except that a single M1XRF2H can handle up to 144 wireless zones (e.g. transmitter sensors or points).
Multiple M1XRF2H receivers can be installed on the data bus allowing hundreds if not thousands of square feet to be covered by strategically placing each receiver in a different location.